Press RESET about 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port No., etc. Press and continue to hold the Reset Button (with a sharp tipped object, like a pen.) Reconnect the power cable while continuing to hold the reset button.
Ireland. Jun 24, 2021. #10. @koppted. This is a pic from the manual. Reset button is shown there. In the manual it looks like there should be some sort of plate covering the circuit board and on that plate there is a button/hole to push a pin into. Do you have that plate? If it has that pin hole than it will locate the button for you.
Page 23: Adding The Nvr To Smart Phone Client. 1.6.2 Adding the NVR to Smart Phone Client This topic takes adding the NVR to smart phone client as an example for smart phone management. Step 1 Open the application and tap Step 2 Select SN/Scan. Figure 1-19 Add device Step 3 Select , enter a name and password for the NVR, and then tap Save.

Step 6: Once the reset process is complete, the Dahua Bullet Camera will be restored to its factory default settings. Step 7: Reconfigure the camera by accessing its web interface or using the

OP could try the following setup: assuming the default IP range for the new DSL-AX82U router is 192.168.1.xxx. - router with DHCP range .50 to .200. - Dahua NVR = set to static IP eg 192.168.1.240. - Dahua IP Villa Door Station = set to static IP eg 192.168.1.241. - 8x cameras set to DHCP & connected directly to NVR PoE ports.
Access Standalone. > PC+ABS housing material, and glass material for front panel , applicable for indoor scenario. > 2.8 inch LCD touch screen display with resolution of 240×320. > Deep learning algorithm makes fingerprint recognition time 1.5 s. > Support card, fingerprint, password.
7g1GS.
  • ooe4cun9zi.pages.dev/585
  • ooe4cun9zi.pages.dev/114
  • ooe4cun9zi.pages.dev/63
  • ooe4cun9zi.pages.dev/154
  • ooe4cun9zi.pages.dev/240
  • ooe4cun9zi.pages.dev/502
  • ooe4cun9zi.pages.dev/371
  • ooe4cun9zi.pages.dev/446

    • dahua cctv factory reset